In this blog post, we look back at how we designed the gearshift robot. At the time, there were one or two other devices on the market which were used in chassis dyno testing, where the vehicle is stationary in a test lab. These used heavy and complex mechanisms to move the gearstick through its range of motion, and didn’t allow you to sit in the driver’s seat.
Blog posts featuring `Transducer Strut`
Accuracy Actuator ADAS ADAS targets adas testing AEB amphibious vehicles Angular Encoder Angular Input Automotive automotive development Autonomous Autonomous Vehicles AV avds averaging Axle binaural car-to-car Career careers case study CAV CBAR Change Gear Chassis dyno connected Connected Vehicles Control System Cut-in Data Data Farming data quality Development Developments DiL drive-by-wire Driveline driver-in-the-loop Driverless Driverless Cars driverless vehicles Driving robots Driving Simulation dual-band durability durability testing dynamics stability Efficiency ELK engineer Engineering ESS EU regulation Euro NCAP Experience Feedback Device Flex-0 frequency Future Gearknob Gears Gearshift GPS GVT Harshness Job kinematics and compliance Knowledge LaunchPad LDW lead in LKA longitudinal control LSS Manual Manual Gearbox Measurement microphone Motion Control Motion Platform multi-vehicles Noise NVH Opportunities path following path-following Payloads Pedestrian Safety Position Feedback powertrain Precision Product Life Cycle prototype proving ground Public Road Testing Quality Control Recruitment Regulations Reliability